Chassis Dynamometers


New for 2011, Mustang Dynamometer introduces the MD-ScooterDyne, a specially designed active eddy...

MD-ScooterDyne. Dynamic Loading Eddy Current Scooter Dyno.

New for 2011, Mustang Dynamometer introduces the MD-ScooterDyne, a specially designed active eddy current loading chassis dynamometer for scooters and moped testing and tuning. The new dyno incorporates twin 6-inch rollers and a 15-hp (11 kW) eddy current power absorber with load cell to apply and measure road load simulation for proper tuning and performance evaluation of scooters and mopeds.

The MD-ScooterDyne is capable of measuring upto 35-hp (26 kW) at a top speed of 110-mph (175 kph). The eddy current PAU provides required loading capabilities to properly tune and simulate road load driving conditions for scooter and rider combinations up to 500 lbs.

The MD-ScooterDyne’s low-profile and cradle roll design makes loading and unloading scooters and moped safe and simple without the need for unnecessary ramps or wheel clamps. Weighing only 90 lbs, the MD-ScooterDyne is mobile and easily transported and sets up in minutes.

The MD-ScooterDyne comes complete with Mustang’s powerful PowerDyne Control Software. A complete data acquisition package allows you to graph RPM, AFR, temps, etc.

Complete systems include MD-ScooterDyne with eddy current PAU and load cell, PowerDyne Software CD, 8 Channel Data Acquisition Package.

MD-ScooterDyne Specifications

HP Measurement:

35-hp (26-kW)

Loading Device:

Air-cooled eddy current power absorber

Torque Measurement Device:

Strain Gauge Type Dynamic Load Cell. Provides closed loop control signal for dynamic vehicle loading.

Peak PAU Absorption:

15-hp (11 kW)

Max Roller Speed:

110-mph (175 Kph)


Closed Loop Digital Controller with WindowsXP based PowerDyne Software. Includes Patented Virtual Road Simulation Technology.


6” diameter rolls. Precision machined and dynamically balanced.

Roll Decelerator:

Eddy Current PAU used to decelerate rollers allows vehicle deceleration without use of vehicle brakes.

Power Requirements:

115 VAC, single phase, 60 Hz, 15 Amps (computer)

230 VAC, single phase, 60 Hz, 40 Amps (dynamometer)

MD-Scooter Dyno

MD-Scooter Dyno
Detailed Specifications for the MD-Scooter Dyno
1.26 MB