Chassis Dynamometers

MD-Gladiator Series

8.575" Rolls, 150-mph, 1,200-hp, 2WD Low-Profile Chassis Dynamometer

MD Gladiator - Ultra-low inertia for precise steady state tuning.

The Gladiator is best suited for real-time, steady state tuning of stand-alone engine management systems such as Autronic, MoTeC, Accel DFI, F.A.S.T., AEM, Haltech and the like.  From a dynamometer stand-point, the main focus of real-time programming is dynamometer sensitivity, resolution, and set-point stability.  The Gladiator’s ultra-low inertia design and high speed controller maximize the user’s experience by minimizing controller “wondering” and enhancing system control-simply dial in a speed and let the Gladiator take over.  Add timing and watch torque increase right on the dynamometer screen in real-time until you have optimized engine timing and fuel mixture.

The Gladiator can be installed above or below ground, it is your choice-however, one of the Gladiator’s main assets is its smaller size-which, of course, makes it easy to install right on the shop floor.  Mustang Dynamometer offers a set of aluminum ramps which can be removed when the dynamometer system is not in use.  Mustang Dynamometer also offers an optional caster kit which allows the Gladiator to be moved about the shop.  This is the ideal dyno for a smaller shop with limited space that does not want to compromise.

    Gladiator Series
    Max Horsepower: 1,200 hp
    Max Absorption: 625 hp
    Loading Device: Air-cooled eddy current power absorber
    Torque Measurement Device: Strain Gauge Type Dynamic Load Cell. Provides closed loop control signal for dynamic vehicle loading.
    Inertia: 630 lbs. base
    Max Speed: 150 mph
    Controls: Closed Loop Digital Controller with WindowsXP based PowerDyne Software. Includes Patented Virtual Road Simulation Technology.

    Precision machined and dynamically balanced

    Front roll set may be grooved horizontally

    8.575” (218mm) diameter balanced rolls

    35” (889mm) face length

    30” (762mm) inner track width (Exceeds EPA/BAR Stds)

    100” (2,540mm) outer track width

    17.1” (434mm) roll spacing

    Roll Lock: Between roll lift with integrated roll lock
    Roll Decelerator: Allows vehicle deceleration without use of vehicle brakes. Eddy Current PAU used to decelerate rollers.
    Air Requirements: 80 PSI, dry, regulated, oil free
    Power Requirements:

    115 VAC, single phase, 60 Hz, 15 Amps (computer)

    230 VAC, single phase, 60 Hz, 40 Amps (dynamometer)

    Axle Weight: 6,000 lbs. maximum
    Shipping Weight: 3,000 lbs. (dynamometer weight only)

      MD-Gladiator Series

      MD-Gladiator Series
      Detailed Specifications for the MD-Gladiator Series.
      1.16 MB

      MD-Gladiator Series

      MD-Gladiator Series
      Conceptual Drawing of the Gladiator
      182.06 kB

      Gladiator Series

      Gladiator Series
      Pit Drawings for the Gladiator Series - For Reference Only, please contact us for official pit specifications.
      205.72 kB

      Hardware/Accessories Catalog

      Hardware/Accessories Catalog
      Dynamometer Hardware & Accessories Catalog
      4.16 MB

      PowerDyne Manual

      PowerDyne Manual
      Detailed User's Manual for Mustang Dynamometer's PowerDyne PC Software.
      4.5 MB

      Quick Start Guide

      Quick Start Guide
      Helpful guide with important tips for new dyno owners.
      743.15 kB