TESTCell provides the Alarm Manager utility for configuring channel limits and alarm conditions. With this utility, alarms and limits are defined based on any channel, either a sensor input or a calculated value. Each alarm incorporates a high limit, low limit, trip delay, and logging feature as well as a minimum of four events to perform after a fault interrupt: warning, shutdown, abort, or a user-defined event. The monitoring of alarms can also be controlled and adjusted during test operation to accommodate multiple alarm scenarios.

Rig Alarms & Events:     High / Low Level Checks     Delayed Trips    Multiple Priorities    User Defined Actions    Alarm on Any Variable    Multiple Alarms Per Variable    Active During Any Test Test Alarms & Events:     Same as Rig Alarms     Active only in specific tests

Rig Alarms Configuration

Test Environment Editor

The Test Environment Editor allows the operator to generate simple to complex test profiles for controlling all system components. Each test profile can contain virtually any number of:    

Waveform Set-up   Ramp Set-up
	Loops    Conditionals    Ramps    Dwells    Waveforms     Alarms    Data Logging    User Interface Screens    Control Loops

1 | 2 | 3 | 4